Move the table to the load position by pressing the Auto Out Button on the table control panel.When the Nozzle Check test print is complete the display will read READY.The display will read PRINTING as the machine performs the Nozzle Check test print.Press the Menu button to accept the PRINT option.The display will read NOZZLE CHECK on the top line and PRINT below.

The display will read NOZZLE CHECK press the Menu button (1) one time to accept.Press the down arrow (1) one time until the display reads TEST PRINT.Press the menu button on the printer control panel 1 time until the display reads PRINTER SETUP.The display will read READY at this point.Press the Auto In button on the machine control panel to move the table to the print ready position.Move the platen/table to the 'print ready' position using the 'manual in' button from the machine control panel until the Transparency Film is just below the Table Height Sensors.Note: Image shows an 8.5' x 11' sheet of white paper instead the transparency film for clarity, be sure that you use a transparency and not a plain white sheet of paper. Place a sheet of 8.5' x 11' Transparency Film on the platen in the most forward right corner.With the machine in the READY state move the table to the 'load' position by pressing the Auto Out Button on the machine control panel.To command the machine to perform a Nozzle Check use the following steps: Required Supplies or Tools: If the Nozzle Check meets specification the ink delivery system is typically in good working order.

A Nozzle Check is a self test print to verify that the Ink Delivery System of the printer is producing adequate ink output.

Ink test page